国产精品久久久久久亚洲,久久欧美一区二区三区性生奴,97影院在线午夜

夢之龍游樂青蟲滑車使用說明書（二）

瀏覽次數: 1389次
發布時間: 2018-06-12

導讀： “青蟲滑車”又叫果蟲滑車，它是童趣園游樂根據市場需要開發研制的一款軌道類游樂設備，此款設備主體是一條大青蟲造型，適用于游樂場、廣場、公園等各類室內外游樂場所，

五、青蟲滑車安全注意事項：Safety precautions:

1、用戶供給游藝機的電源應有漏電開關保護，且電源插座中的接地極必須與保護接地線（網）可靠連接，各組電氣導線的連接必須由專業電氣安裝人員操作。

The power supply should have leakage protection , And the grounding in the power supply socket must connect with the protect ground wire (Network) . Each group of electrical wire connection must be operated by professional electrical installation personnel. The connecting of electrical conductor should operated by professional Electrical installation personnel

2、電控柜金屬外殼，機架必須與保護接地線可靠連接。（接地電阻≤10Ω）

The shell of control , frame must connect with Grounding wire.(The grounding resistance< 10Ω)

3、游藝機安全停穩后，兒童才能進入或離開機艙。

After the equipment stop well, then Kids can be allow to enter or left cabin.

4、座艙內的乘客未坐好，不允許啟動游藝機。

Before passenger sit down well, don’t allow to start the equipment.

5、游藝機在運行時，嚴禁任何人進入圍欄內，嚴禁乘客離開座艙。

When the equipment is running, do not allow anyone to enter the fence, do not allow passenger leave cabin.

6、游藝機運行不正?；虿荒茏詣?dòng)停機，應立即關掉電源總開關，或撥掉電源插頭。

The equipment is not running properly, or can not stop automatic, should turn off the power switch, or pull out the power plugs.

7、在檢修游藝機期間，必須事先將電源切斷。

During the overhaul of amusement machine, Power supply must be cut off in advance

8、更換保險管時，必須選用與原規格一致的保險管。

Replacement of the insured, Must choose the same as the original specifications of the insurance tube

9、潮濕大風雷雨天氣不可運行設備。

The equipment can not use in Wet and windy thunderstorm weather.

六、青蟲滑車保養與維修：Maintenance and repair

1、應經常保持游藝機內，外的清潔。

Should always keep the game machine inside and outside the clean.

2、游藝機投入使用前，要檢查整機各件的情況，對緊固件要認真檢查，以后要定期或不定期的檢查，緊固。

Before entering the game machine, to check the situation of the machine parts, fasteners to be carefully checked, after regular or irregular inspection, fastening

3、定期或不定期檢查。

Regular or irregular inspection

4、視使用情況，對齒輪，軸承定期或不定期加注潤滑脂。

Depending on the use of the gear, bearing periodic or irregularly filling grease.

5、新游藝機使用一段時間后，應檢查。

After a period of use of new recreational machines should be checked

6、若游藝機長時間不投入使用，則至少每月啟動運行4-8小時，使游藝機的機械，電氣系統能保持良好的工作狀態。

7、 If the game machine is not put into use for a long time, at least monthly start running 4-8 hours, so that the game machine mechanical and electrical systems can maintain a good working condition

8、電控柜要作好防雨，防潮，防浸措施。

Electric control cabinet to do a good job of rain, moisture, dipping measures.

七、青蟲滑車故障及檢修：

故障現 象 Fault analysis	故障分析 Fault analysis	檢修排除方法 Troubleshooting methods
電動機不能啟動 Motor can not be started	電動機的離心開關合不上，或位置偏移，不清潔致使接觸不良。 2. Centrifugal switch of motor can not closed or Position offset . Uncleanness makes bad connection	檢查離心開關，調整位置，清潔觸頭。 Check centrifugal switch Adjust switch position Clean the connection
	電動機極掌與轉子間有線圈扎線熔斷。 There is coil Fuse between the Motor pole palm and rotor	將斷口處理好。 Repair the fracture
	各軸承，傳動件失油，內有污物，軸承損壞等導致轉動運轉不靈。 1.Bearings and driving mediums lost oil 2.There is dirt inside 3.Bearings failure	對軸承，轉動件等清洗，加油，甚至更換軸承。 1.Clean the bearings and driving mediums 2. Add oil. 3..Change bearings
	電容擊穿 Capacitor breakdown	更換電容 Change the capacitor
	電容擊穿 Capacitor breakdown	修理機械傳動部分。 Repair the transmission parts
啟動后，游藝機不能正常運行 The machine can’t work when press the start button	過流使開關C45N自動切斷電源 The overcurrent switch C45N stop the power supply automatic	檢查電動機和過流開關。 Check the electromotor and the overcurrent switch
游藝機不能在定時控制時間內自動停止運行 The machine can’t stop at the adjusted time	接插件松動， The connector is loose	檢查各接插點。 Check all the connector
	定時數值開關接觸不良，或定時電路板有故障。 The switch of timing set is bad connected or the circuit board don’t work well	檢修或更換 Check and change